1-6.
Maintenance & Upkeep
● Wipe off and clean the sensors after each use to avoid rust. If the sensor electrode and attachment have fish
slime or sea salt water, it may rust. Use a wet wipe or towel to clean off the sensors.
● Do not drop and avoid vibrations. Use a strap that is provided through the strap hole.
● After replacing the batteries, make sure the battery cover is securely tight to avoid water, sand or any other
foreign debris. If it’s not securely tight, it may not be fully waterproof.
● The following images show how to slide the battery cover off and clean inside the battery box. Clean the inside
of the battery box often and close the battery cover firmly when done.
Wipe off dirt and dust with a dry tissue for battery contacts. Wipe
off any moisture. If any battery erosion or leaks are found,
contact the distributor or place of purchase for detailed handling.
To make sure the battery cover is securely
tight, push the battery cover firmly from the
bottom so that there is no gap. Match the
lines on the main unit as indicated below.
● If the attachment is used, use the same care as above. Wipe off fish slime, sea salt water, dirt or any other
foreign debris each time after measurement.
Be sure to wipe off any dirt
from the sensor electrodes
with water or alcohol before
mounting the attachment.
If dirt is found on the connection terminal of
the attachment, moisten the tip of the swab
with water or alcohol, then slide the swab
toward the inside of the connection terminal
to wipe off dirt.
Be careful. If you press the
outside of the connection
terminal downward, the
connection terminal will bend
outward.
8
Содержание DFA110
Страница 28: ...PRINTED IN JAPAN 27 ...