34 (42)
6.9
Minor superficial repairs
You can repair minor surface damage to the boat's deck yourself. However, achieving a neat,
unnoticeable repair requires a considerable amount of skill:
1.
Protect the area around the damage with tape.
2.
Bevel the edges of the damaged area and clean with acetone.
3.
If the damage is deeper than 2 mm, it is advisable to smooth it with an appropriate
polyfiller before painting.
4.
Mix topcoat with 1.5-2 % hardener.
5.
Fill the repair with more topcoat than needed, so that its surface remains slightly
proud of the surrounding area.
6.
Carefully put tape over the repair.
7.
After the topcoat has hardened, remove the tape and sand the repair using 600 and
1200 paper applying water.
8.
Buff using abrasive paste and wax.
The colours used on this boat are specified in the t
echnical specifications
. One point to
consider is that a paint called gelcoat has been used in manufacturing the boat, but the
surface is always repaired with a paint called topcoat. Gelcoat paint does not harden without
a mould surface, whereas paraffin has been added to topcoat to allow it to harden.
WARNING!
Be careful when handling the hardening agent. If the hardening
agent vessel/bottle leaks, or if hardener falls on, e.g., a dirty floor
or rag, there is a very high risk of fire. Do not throw rags or vessels
containing topcoat/hardener mixture into the rubbish bin. Always
use eye protection when handling topcoat or hardener. If you get
hardener in your eyes, rinse your eyes immediately with tap water
and see a physician.
NOTE!
Post-delivery installations and alteration work may cause damage
to the structure of the boat or impair safety if not performed
correctly. Please contact the dealer if you are planning any
modifications.
NOTE!
It is important to use aluminum or stainless steel screws and
rivets when installing accessories. There are ready-made fittings
for a depth finder sensor (Garmin) on the boat's transom.
NOTE!
When installing accessories on an aluminum surface
(except in
their pre-ordained places)
, always use aluminum rivets and
insulating washers to avoid corrosion.
Содержание Cross 49 Bow Rider
