PERIODIC MAINTENANCE AND ADJUSTMENT
7
-10
7
3. Remove the engine oil filler cap
and the drain bolt along with the
O-ring, compression spring, and
engine oil strainer, to drain the oil
from the crankcase.
NOTICE:
When removing the engine oil
drain bolt, the O-ring, compres-
sion spring, and oil strainer will
fall out. Take care not to lose
these parts.
[ECA11001]
4. Clean the engine oil strainer with
solvent.
TIP
Skip steps 5–7 if the oil filter element
is not being replaced.
5. Remove the oil filter element cov-
er by removing the bolts.
6. Remove and replace the oil filter
element and O-ring.
7. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
TIP
Make sure that the O-ring is properly
seated.
8. Install the engine oil strainer,
compression spring, O-ring and
the engine oil drain bolt, and then
tighten it to the specified torque.
1. Engine oil drain bolt
2. O-ring
3. Compression spring
4. Strainer
5. Oil pan
1
5
2
3
4
1. Bolt
2. Oil filter element cover
1
2
1. Oil filter element
2. O-ring
Tightening torques:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 9.2 ft·lbf)
1
2
54CF8199E1.book Page 10 Thursday, April 1, 2010 1:24 PM
