4-10
Operation
6.
To stop the Snowblower, lower the auger to the
ground and move the shift lever to a position other
than the “N” (Neutral) position.
Moving the snowblower with the
engine stopped
Follow the step below to move the Snowblower with the
engine stopped.
1.
Remove the sprocket pin from the sprocket wheel
by pulling on the ring.
2.
Insert the sprocket pin into the hole of the wheel
axle and then fold the ring of the sprocket pin.
TIP
Remove the sprocket pin from the both side of the
wheels.
3.
The sprocket wheel is now freed from the wheel
axle. Move the Snowblower by pushing and pull-
ing, holding the handles.
4.
After moved the Snowblower to the desired posi-
tion, insert the both sprocket pins into the original
places.
Position the Snowblower on a level surface. If you
need to stop it on angled or soft ground, exercise
care not to fall off or move the Snowblower.
WARNING
• Do not start the engine.
• Position the Snowblower on a level surface
before proceeding with the following procedure.
NOTICE
1
2
4
3
1. Ring
2. Sprocket pin
3. Hole
4. Sprocket wheel
7XE-28199-U6-E0.book 10 ページ ２０２０年５月１日 金曜日 午後３時４３分