23
1
Air filter case
2
Seat lock
3
Tensioner
4
Crankcase breather hose
5
Fuel sender
6
Throttle cable
7
Seat lock cable assembly
8
Panel
9
Footrest board
10
Radiator resorvoir tank breather
hose
11
Vacuum hose
12
Throttle position sensor lead
13
Seat lock
14
Auto choke lead
15
Brake hose assembly
16
A. C. magneto lead
17
Starter motor lead
18
Engine ground lead
19
Wireharness
A Don’t turn the idle adjust screw,
when fix the hose.
B Route the gray seat lock outer
cable through the left side of
frame.
C Set the fuel tank sender lead and
sub lead.
D Fasten the wireharness on the
frome with a band and the end of
band match the tank rail pipe
angle.
E Fix the seat lock cable along the
guide of panel.
F Fasten the wireharness on the
frame with a plastic clamp.
G Fasten the starter motor lead on
the fuel tank brocket with a plas-
tic locking tie.
H Route the starter relay lead to-
ward inside.
I Route the battery negative lead
toward inside.
CABLE ROUTING
SPEC
Содержание YP250 5GM2-AE1 2000
