9-22
9
9. Connect the coolant reservoir hose.
10. Pour the recommended coolant into the res-
ervoir to the maximum level mark, and then
install the reservoir cap.
11. Pour the recommended coolant into the radi-
ator until it is full, and then install the radiator
cap.
12. Start the engine, let it idle for several minutes,
and then turn it off.
TIP
While the engine is idling, check the cooling sys-
tem for leaks.
13. When the engine is cool, remove the radiator
cap to check the coolant level in the radiator.
If it is low, add sufficient coolant until it reach-
es the top of the radiator, and then install the
radiator cap.
14. Install the panel.
EBU2680A
Cleaning the air filter element
The air filter element should be cleaned at the in-
tervals specified in the periodic maintenance and
lubrication chart. Clean or, if necessary, replace
the air filter element more frequently if you are rid-
ing in unusually wet or dusty areas.
TIP
There is a check hose at the bottom of the air filter
case. If dust or water collects in this hose, empty
the hose and clean the air filter element and air fil-
ter case.
1. Park the ATV on a level surface.
2. Remove the seat. (See page 5-12.)
3. Remove the air filter case cover by unhooking
the holders.
1. Air filter case check hose
1
UBCX60E0.book Page 22 Friday, April 19, 2019 9:09 AM
