Yamaha XT660R, Руководство по обслуживанию

Страница: 429 / 462

8 - 47
– +
ELEC
SIGNALING SYSTEM
YES
NO
7. The coolant temperature warning light fails
to come on.
YES
NO
YES
NO
2. Speed sensor
• Connect the pocket tester (DC 20 V) to the
speed sensor coupler as shown.
Positive tester probe
→
pink
1
Negative tester probe
→
black/white 2
• Set the main switch to “ON”.
• Elevate the rear wheel and slowly rotate it.
• Measure the voltage (DC 5 V) of pink and
black/white. With each full rotation of the
rear wheel, the voltage reading should
cycle from 0.6 V to 4.8 V to 0.6 V to 4.8 V.
• Does the voltage reading cycle correctly?
This circuit is OK. Replace the speed
sensor.
P O
/ R
B / W
L W
B / L
1
2
1. Coolant temperature warning light LED
• Check the LED of the coolant temperature
warning light.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”.
• Is the coolant temperature warning light
LED OK?
Replace the meter
assembly.
2. Voltage
• Connect the pocket tester (DC 20 V) to the
meter assembly coupler (wire harness
end) as shown.
Positive tester probe
→
yellow/blue 1
Negative tester probe
→
black/white
2
• Set the main switch to “ON”.
• Measure the voltage (DC 5 V) of yellow/
blue 1 on the meter assembly coupler
(wire harness end).
• Is the voltage within specification?
The wiring circuit
from the ECU to the
meter assembly cou-
pler is faulty and
must be repaired.
Dg G / L R / W
Ch R / G Y
B / W Lg
G / W Y / L
Ch R / G Y
G G / L R / W
G / W Y / L
B / W Lg
1
2