Yamaha WaveRunner VX 700, Руководство по обслуживанию

Страница: 119 / 181

6-14
1
2
3
4
5
6
7
8
9
A
Joint removal
Do not touch the joint or adhesive that
was heated by the heat gun with your bare
hands; they will be very hot and could
cause burns.
1. Set a heat gun 1 to 350 °C (662 °F) and
use it for about 20 minutes to heat the
joint and adhesive.
2. Once the adhesive has softened, use a
flat head screwdriver to remove the joint
2 from the hull.
TIP:
• When using the heat gun, be careful not to
direct the heat towards any hoses or rubber
parts.
• After removing the joint, clean off any adhe-
sive remaining on the hull.
Joint installation
1. Apply urethane adhesive
1
(MWV-
GLUET-UB) to the hull in the area shown
in the illustration using the glue gun
2
(MWV-GLUEG-UN), and then install the
joint.
TIP:
Before installing the joint, clean the contact
surfaces of the joint and hull to remove any
dirt.
2. Tighten the bolts 3 to the specified
torque.
1
2
Joint bolt
3
: 7 N·m (0.7 kgf·m, 5.2 ft·lb)
1
2
3
3
Intermediate drive shaft assy.