Yamaha VMX12H, Дополнительное руководство по обслуживанию

Страница: 173 / 405

MIDDLE GEAR SERVICE
0.
1,2
3.4. 6
U
0
5
3-49
6. Tighten:
Bolt (Three)
Tighten carefully one-threadturn only. Push
in bearing housing and hold in position
while tightening bearing housing bolts.
10
Do not overtighten bearing housing bolts or you
may obtain too little gear lash and cause damage
to gears. If over tightened, loosen the 3 bolts so
that crankcase/bearing housing clearance is
steps.
about
2
mm (0.08 in) and repeat all previous
Thickness (mm)
7. Repeat steps 4 and
5
until correct gear lash
is achieved.
0.1 0
0.15
0.30
0.50 0.60
Middle Gear Lash:
0.05 0.12 mm (0.002 0.005 in)
8. Measure:
Crankcase/bear
ing housing clearance
Use a Feeler Gauge.
9.
Select:
By the following steps.
Example: Selection of the driven pinion gear
shim;
If the clearance is 0.46 mm.
shim can only be selected in 0.05 mm
increments, round off hundredths digit and
select appropriate shim
Hundredths
the example above, the measured shim
thickness is 0.46 mm. The chart instructs
you, however, to round off the 6 to 5. Thus
you should use 0.15 mm and
0.30
mm
shims.
sizes are supplied in the following
thickness.
Driven Pinion Gear Shim