Perio
d
ic maintenance an
d
a
d
justment
7-9
7
4. If the engine oil is not between the
tip of the dipstick and the maxi-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
5. Check the O-ring for damage, and
replace it if necessary.
6. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
To chan
g
e the en
g
ine oil
1. Start the engine, warm it up for
several minutes, and then turn it
off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap,
the engine oil drain bolt and its
gasket to drain the oil from the
crankcase.
4. Install a new gasket and the drain
bolt, and then tighten the drain
bolt to the specified torque.
5. Refill with the specified amount of
the recommended engine oil.
NOTICE
ECA11621
In or
d
er to prevent clutch slip-
pa
g
e (since the en
g
ine oil also
lu
b
ricates the clutch),
d
o not
mix any chemical a
dd
itives. Do
not use oils with a
d
iesel speci-
fication of “CD” or oils of a hi
g
h-
er quality than specifie
d
. In
a
dd
ition,
d
o not use oils la
b
ele
d
“ENERGY CONSERVING II” or
hi
g
her.
Make sure that no forei
g
n mate-
rial enters the crankcase.
6. Check the O-ring for damage, and
replace it if necessary.
7. Install and tighten the engine oil
filler cap.
8. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off
and check for the cause.
1. Engine oil drain bolt
2. Gasket
Ti
g
htenin
g
torque:
Engine oil drain bolt:
20 N·m (2.0 kgf·m, 15 lb·ft)
1
2
Recommended engine oil:
See page 9-1.
Oil change quantity:
0.80 L (0.85 US qt, 0.70 Imp.qt)
1. Engine oil filler cap
2. O-ring
2
1
UB5183E0.book Page 9 Friday, June 9, 2017 8:32 AM
