E-8
RX-E100 BASIC OPERATIONS
Listening to a source
4
Play the source. (Refer to the owner’s manual
supplied with each selected component.)
5
Adjust the volume level by turning
VOLUME
on the
front panel or pressing
on the remote
control.
6
If desired, adjust
BASS
,
TREBLE
, and
BALANCE
.
BASS:
Turn this control clockwise to increase (or
counterclockwise to decrease) the low frequency
response.
TREBLE:
Turn this control clockwise to increase (or
counterclockwise to decrease) the high frequency
response.
BALANCE:
Adjust the balance of the output volume
from the left and right speakers to compensate for
sound imbalance caused by the speaker location or
listening room conditions
• These controls are only effective for the sound from the main
speakers.
When you use headphones
Connect the headphones to the
PHONES
jack. You can
listen to the sound from the main speakers through the
headphones.
When you have finished using this
unit
Press
STANDBY/ON
on the front panel again or
POWER
on the remote control to set this unit to the
standby mode.
• The
STANDBY
indicator lights up.
Auto power off function
RX-E100 will be put automatically into the standby mode
under the following conditions:
• The component connected to RX-E100 is in stop mode
and not operated for 30 minutes.
•
TUNER
or
AUX
is not selected as an input source.
STANDBY/ON
PHONES
DISPLAY
+
-
+
-
R
L
MEMORY
AUTO/MAN'L
TIME ADJ
TIMER
HOUR
PTY SELECT
MIN
BASS
TREBLE
BALANCE
MAX
MIN
VOLUME
INPUT
PRESET/TUNING
PRESET/BAND
NATURAL SOUND STEREO RECEIVER RX-E100
TIMER
STANTBY
VOLUME
STANDBY/ON
INPUT
BALANCE
TREBLE
BASS
PHONES
A
D
C
E
B
TIME
RNDM
VOLUME
MODE
PTY SEEK
FREQ PS/PTY/RT/CT
START
TAPE
AUX
MD
CD
TUNER
PRESET
PTY SELECT
TAPE
MD REC
MODE
START
TAPE REC
PROG
TAPE
REP
PEAK
DUBBING
SLEEP
DISP
POWER
VOLUME –/+
1
Set the volume to “
MIN
” by turning
VOLUME
.
2
Turn on the power by pressing
STANDBY/ON
on
the front panel, or
POWER
on the remote control.
• RX-E100 can be used to turn on or put in standby mode
the system connected E100 series components depending
on their prior standby/on status.
3
Select the desired input source by turning
INPUT
so
that the source appears on the display.
• When you operate the component connected to the
AUX
terminal, turn
INPUT
to select
AUX
.
