TROUBLESHOOTING
42
En
The power is
suddenly turned off.
The sleep timer is set.
This is not malfunction. Turn on this unit and play
the source again.
[Auto Power Off] is set to [On].
Set [Auto Power Off] to [Off].
The clock setting has
been cleared.
The power cable has been disconnected.
Connect the power cable, and set the clock again.
—
Sound is heard from
the speaker on one
side only.
Incorrect cable connections.
Connect the cables properly. If the problem persists,
the cables may be defective.
There is noise
interference from
digital or radio
frequency
equipment.
This unit is too close to the digital or
high-frequency equipment.
Move this unit farther away from such equipment.
—
This unit makes a
snapping sound
when starting
playback or loading a
disc.
These sounds are not malfunctions of this unit but
are normal operating conditions.
—
No sound from the
subwoofer.
The subwoofer is not connected properly.
Check that the subwoofer is connected properly.
The system settings
change
automatically.
When [HDMI Control] is set to [On],
operations of the TV (for example,
changing channels, etc.) changes the
system settings.
Set [HDMI Control] to [Off] or set the system again
by using its remote control.
The HDMI control
function does not
work properly.
[HDMI Control] is set to [Off].
Set [HDMI Control] to [On].
The HDMI control function is disabled
on your TV.
Refer to the manual supplied with your TV and
check the setting.
—
The automatic
lipsync is not
effective even [Lip
Sync] is set to [Auto].
The TV does not support the automatic
lipsync.
Set [Lip Sync] to [Manual] and then manually adjust
the audio output delay.
Radio reception
Problem
Cause
Remedy
Page
FM stereo reception is
noisy.
The antenna is connected improperly.
Check the antenna connections.
The characteristics of FM stereo
broadcasts cause this problem when the
transmitter is too far away or the
antenna input is poor.
Try using a high-quality directional FM antenna.
—
Switch to monaural mode.
The desired station
cannot be tuned into
with the automatic
tuning method.
The signal is too weak.
Use a high-quality directional FM antenna.
—
Use the manual tuning method.
The preset selecting
function does not
work.
The preset (memory) has been erased.
Preset radio stations again.
There is distortion,
and clear reception
cannot be obtained
even with a good FM
antenna or an outdoor
antenna.
Multipath reflection or other radio
interference has occurred.
Change the height, direction, or placement of the
antenna.
—
Problem
Cause
Remedy
Page