Installation and Connection
10
En
■
Adjust the height of center unit
In case that the center unit straddles the stands of your TV,
turning the stands to left makes the unit higher. Confirm the
graduation of each stand to make each stand the same height.
Adjust the graduation in the range from 0 to 10.
■
Remove the center unit legs
When the center unit hides the remote control sensor or signal
transmitter for 3D glasses of your TV, turn the center unit over,
remove the legs, and use supplied pads as shown below.
1 Turn the leg furthermore to the left.
2 Remove the outside part of the leg.
3 Push the whole leg to the center of the bottom as
shown in the illustration while laying the hook to the
same direction, and then remove the inside part of
the leg.
4 Attach the 4 non-skid pads (supplied) to the corners
on the bottom of the center unit. (The illustration
below is one of the examples for attaching the non-
skid pads.)
■
When the center unit hides the remote
control sensor of your TV
The unit receives the signal from the remote control of your TV
in front, and transmits to your TV by IR Flasher (supplied).
Remove the backing paper on the tip of LED part of IR Flasher,
and attach it to the remote control sensor of your TV or the area
close to the remote control sensor of your TV on the rear panel of
center unit as shown. Connect the plug to the IR output jack of the
unit.
Install the subwoofer with the supplied stands. Attach the
supplied stands with the dowels to the subwoofer. Changing the
position of the stands enables both horizontal placement and
vertical placement. Horizontal placement is convenient for
installing the center of a rack, and vertical placement is
convenient for installing the side of a rack.
The graduation
Adjustable range:
28.5mm to 38.5mm
(1-1/8 in to 1-1/2 in)
Non-skid pad
Attach the stands to the subwoofer
IR Flasher (supplied)
Remote
control
sensor of
your TV
•
When using IR Flasher, direct the remote control of your TV to
the center unit.
•
This function is valid even in the standby mode.
•
This function may not activate with some TVs.
Notes
Horizontal placement
Vertical
placement
