Maintenance
49
and storing it. If storing or transporting
the outboard motor on its side (not up-
right), put it on a cushion after draining
the engine oil.
●
Do not place the outboard motor on its
side before the cooling water has
drained from it completely, otherwise
water may enter the cylinder through
the exhaust port and cause engine trou-
ble.
●
Store the outboard motor in a dry, well-
ventilated place, not in direct sunlight.
EMU28303
Procedure
EMU28332
Flushing in a test tank
CAUTION:
ECM00300
Do not run the engine without supplying
it with cooling water. Either the engine
water pump will be damaged or the en-
gine will be damaged from overheating.
Before starting the engine, be sure to
supply water to the cooling water passag-
es.
1.
Wash the outboard motor body using
fresh water. For further information, see
page 52.
2.
Disconnect the fuel line from the motor
or shut off the fuel cock, if equipped.
3.
Remove the engine top cowling and si-
lencer cover. Remove the propeller.
4.
Install the outboard motor on the test
tank. Fill the tank with fresh water to
above the level of the anti-cavitation
plate.
CAUTION:
ECM00290
If the fresh water level is below the level
of the anti-cavitation plate, or if the water
supply is insufficient, engine seizure may
occur.
5.
Cooling system flushing is essential to
prevent the cooling system from clog-
ging up with salt, sand, or dirt. In addi-
tion, fogging/lubricating of the engine is
mandatory to prevent excessive engine
damage due to rust. Perform the flush-
ing and fogging at the same time.
WARNING
EWM00090
●
Do not touch or remove electrical parts
when starting or during operation.
●
Keep hands, hair, and clothes away
from the flywheel and other rotating
parts while the engine is running.
6.
Run the engine at a fast idle for a few
minutes in neutral position.
7.
Just prior to turning off the engine, quick-
ly spray “Fogging Oil” alternately into
each carburetor or the fogging hole of
the silencer cover, if equipped. When
properly done, the engine will smoke ex-
1. Water surface
2. Lowest water level
ZMU02051
1
2
Содержание FT25B
Страница 1: ...OWNER S MANUAL F20A F25A FT25B 65W 28199 7D E0...
Страница 6: ...Table of contents Treatment of submerged motor 78 Procedure 78...
Страница 85: ......
Страница 86: ...YAMAHA MOTOR CO LTD Printed on recycled paper Printed in Japan April 2007 0 5 1...