Yamaha F200B, Руководство по обслуживанию

Страница: 549 / 579

10-8
10
3. For the remaining 8 hours
c
of opera-
tion:
Operate the engine at any engine speed.
However, do not operate the engine at
full throttle for more than 5 minutes at a
time.
4. After the 1st 10 hours of operation:
Operate the engine normally.
È
Hour
After test run
1. Check for water in the gear oil.
2. Check for fuel leakage in the cowling.
3. Flush the cooling water passages using
fresh water.
NOTICE: When flushing
the cooling water passages, do not
start the engine. Otherwise, the water
pump could be damaged and the
engine could be severely damaged
due to overheating.
TIP:
When using the flushing device (flushing
hose joint adapter), flush the cooling water
passages without starting the engine.
General periodic maintenance
Inspecting and replacing anode(s)
Do not apply, grease, oil, or paint to the
anodes or the trim tab.
1. Check the anodes and trim tab. Clean
the anodes or trim tab if there are scales,
grease, or oil.
TIP:
• Replace the anodes or trim tab if eroded. In
addition, check the ground lead.
• If it is necessary to disassemble the out-
board motor to check an anode, refer to the
applicable disassembly procedure in this
manual.
Checking battery (for electric start
models)
1. Check the battery. See “Checking battery
(for electric start models)” (10-4).
Checking for cooling water leakage
1. Start the engine and check that no water
leaks from the joints between the
exhaust cover, cylinder head, cylinder
body and so on.
Checking the cooling water passage
1. Remove the water inlet covers
1
and
trim tab
2
.
2. Check the cooling water inlet covers
1
and water inlets. Clean if clogged.
0 1 2 10
È
a b c
1
1 3
4
2
a
Predelivery check / General periodic maintenance