Yamaha EMX 5000-12, Руководство пользователя

Страница: 18 / 38

16
Front and rear panel
EMX5000-20/EMX5000-12—Owner’s Manual
Input/output panel
1
Channel input jacks (INPUT A, INPUT B)
EMX5000-20: 1–16, EMX5000-12: 1–8
By using the GAIN control (control panel
2
)
you can connect any of the jacks to a wide range
of sources, from mics to line-level devices
(including synthesizers and rhythm machines).
The INPUT A jacks can p48V phantom
power, allowing you to use condenser micro-
phones.
The nominal input level is from –16 dB to –60 dB
when the 26 dB pad switch (control panel
1 ) is
off, or from +10 dB to –34 dB when it is on.
Both INPUT A and B are balanced.
They are compatible with microphones of output
impedance 50–600
Ω
or line level devices of
600
Ω
.
Pin connections for the jacks are as follows:
* You can also connect a normal unbalanced phone plug.
2
INSERT I/O (insert) jacks
These are TRS phone jacks that enable you to
insert an external effect processor, such as a com-
pressor/limiter, between the equalizer and fader
of input channels. These connections require a
special “Y” cable, such as shown in the following
diagram. The nominal input/output levels are
0 dB.
A 5 6 8 E F G 0
D
1 4 3
2 7 B
C
9
INPUT A jacks
(XLR type)
INPUT B jacks
(TRS phone jacks) *
Pin 1: ground Sleeve: ground
Pin 2: hot (+) Tip: hot (+)
Pin 3: cold (–) RIng: cold (–)
GND
R S T
+ -
GND
+ -
1 2
3
Note: It is not possible to simultaneously use
both the INPUT A and B inputs of a given
channel. For each channel, use only one of the
inputs as appropriate for the input source.
Phantom power is switched on/off simulta-
neously for channels 1–8 and 9–16 (EMX5000-
20), 1–8 (EMX5000-12). For this reason, devic-
es (in particular, unbalanced devices) other
than condenser microphones must be connect-
ed to the INPUT B input jacks of channels or
channel 17/18–19/20 (EMX5000-20), 9/10–11/
12 (EMX5000-12) input jacks if the PHAN-
TOM +48V switch (control panel
3 ) is on.
to the input jack of
the external processor
to the output jack of
the external processor
to the INSERT I/O jack
Tip
Tip
Ring
Sleeve
Sleeve