Yamaha EMX 5000-12, Руководство пользователя

Страница: 17 / 38

Control panel
15
EMX5000-20/EMX5000-12—Owner’s Manual
■
POWER indicator
[
POWER indicator
This indicator will light up when the power of the
EMX5000-20/EMX5000-12 is turned on.
■
YAMAHA SPEAKER PROCESSING
\
ON/OFF switch
This switch enables you to compensate the low
range of the speakers. The low range balance
when this switch is on varies depending on the
speakers.
First, check the low range balance by auditioning
the resultant sound, then set this switch to on or
off.
■
STAND-BY
]
ON/OFF switch
This switch mutes (silences) the input signals
from channels 1–16 (EMX5000-20) or channels
1–8 (EMX5000-12). The indicator will blink
when this switch is on.
■
Other indicators and controls
^
Peak level indicator
This indicator allows you to monitor the level of
the signal output from the ST OUT jacks. The “0”
indicator lights up when the output level reaches
+4 dB.
a
PHONES control
This knob adjusts the level of the signal moni-
tored via the PHONES jack (input/output panel
D
).
b
ST SUB OUT control
This knob adjusts the final level of the signal sent
from the STEREO bus to the ST SUB OUT jacks
(input/output panel
A
).
c
LPF control, ON/OFF switch
This switch applies a low-pass filter to the signal
that is output from the PFL/AFL bus to the
MONO OUT jack. The frequency is indicated by
the position of the slit in the control trimmer that
is set into the panel above the switch. To adjust
the frequency, use a slotted screwdriver to turn
the control to the desired position. This will out-
put the region below the frequency (80–120 Hz)
you specify by the control knob.
Use this when you are using a sub-woofer.
[
\
]
Note: The setting of this control does not affect
signals that are sent from the STEREO bus to
the ST SUB OUT jacks and the SPEAKERS
jacks.
c
`
b
a