Yamaha DTXPRESS, Руководство пользователя

Страница: 66 / 88

66
Trouble Shooting
The DTXPRESS does not produce sound, and does not recognize trigger inputs.
●
Is the pad or trigger sensor properly connected to the DTXPRESS’ trigger input jack? (
m
P. 10)
●
Is the volume knob on the front panel turned down? (
m
P. 8)
●
Is the input level displayed when the pad is hit? (
m
P. 36 [1-2. Gain, Minimum Velocity])
●
Is the gain set too low? (
m
P. 36 [1-2. Gain, Minimum Velocity])
●
Is the Utility mode’s [1-2. Trigger Bypass] bypass switch set to “ON”? (
m
P. 52)
●
Is the Drum Kit Voice Edit mode’s [1-2. Volume, Pan] (
m
P. 41) or [5-1. Volume] (
m
P. 47) volume set to “0”?
●
Check the local control setting in the Utility mode. When the local control is set to “off ” the DTXPRESS will not
produce sound when the pads are hit. (
m
P. 55 [2-6. Device Number, Local Control])
●
Is the cable you are using OK?
The external tone generator does not produce sound.
●
Is the MIDI cable (connector) properly connected? (
m
P. 12)
●
Are the MIDI note number values proper? (
m
P. 42 [1-7. Channel, Gate Time])
●
Is the Utility mode’s [1-2. Trigger Bypass] bypass switch set to “ON”? (
m
P. 52)
A voice other than the set voice is produced.
●
Is the transmitting MIDI channel set to a channel that is not used for the drum voice (ch=10)?
(
m
P. 42 [1-7. Channel, Gate Time])
●
Is the Voice=2 parameter set for a 2 layer voice? (
m
P. 41 [1-1. Voice])
Produces sound but the sensitivity is too low (volume is low).
●
Is the gain set too low? (
m
P. 36 [1-2. Gain, Minimum Velocity])
●
Pads with output or sensitivity control volumes should be adjusted (increased).
●
Is the minimum velocity set too low? (
m
P. 36 [1-2. Gain, Minimum Velocity])
●
Is a proper velocity curve being used? (
m
P. 37 [1-3. Velocity Curve])
●
Is the volume of the voice you want to use too low? (
m
P. 41 [1-2. Volume, Pan])
●
Is the drum head getting old?
●
Change the INPUT ATTENUATION setting on the rear panel. (
m
P. 9)
The trigger sound is not stable (for acoustic drums).
●
Check the “Produces sound but the sensitivity is too low (volume is low).” list above.
●
Is the proper pad type set? Select a larger pad type setting (DT snare
m
DT hi tom
m
DT lo tom
m
DT kick 1
m
DT kick 2) (
m
P. 36 [1-1. Pad Type])
●
Is the DT10 properly attached with sticky tape? (Is there any old sticky tape remaining on the head?) (
m
P. 11)
●
Is the cable securely connected to the DT10 jack?