Assembling the Unit
38
•
N1
Owner’s Manual
3-2
Move the main unit slightly toward the rear side,
then adjust its position so that the projecting pin on
the metal brackets on the bottom of the main unit
will lock into the notch on the metal brackets of the
legs (L/R).
4
Secure the main unit.
Secure the main unit using ten long screws (6 x 30 mm).
5
Connect the speaker cord and pedal cord.
5-1
Remove the vinyl tie attaching the speaker cord and
pedal cord.
5-2
Insert the speaker cord plug into the connector so
that the tab extends toward the front when viewed
from the rear.
5-3
Insert the pedal cord plug into the pedal connector
in the correct orientation.
5-4
Use vinyl ties to bundle the speaker cord and pedal
cord.
6
Attach the speaker net.
6-1
Attach the speaker net.
6-2
Affix the speaker net with the screws unloosed at
step 2.
7
Insert the AC power cord plug into the AC
INLET.
For models that feature a voltage selector: Set the voltage
selector to an appropriate voltage.
8
Rotate the adjuster until it comes in firm
contact with the floor surface.
Connecting the pedal cord
Insert the pedal cord securely until the metal part
of the cord plug disappears from view. Other-
wise, the pedal may not function properly.
5-1
5-4
5-1
5-4
5-2
5-3
After completing the assembly, please
check the following.
• Are there any parts left over?
Review the assembly procedure and correct any errors.
• Is the instrument clear of doors and other movable fixtures?
Move the instrument to an appropriate location.
• Does the instrument make a rattling noise when you shake
it?
Tighten all screws.
• Is the power cord inserted securely into the sockets?
Check the connection.
• If the main unit creaks or is otherwise unsteady when you
play on the keyboard, refer to the assembly diagrams and
retighten all screws.
240
127
11
0
220
