Components
17
EMU26373
Cowling lock lever(s) (turn type)
To remove the engine top cowling, turn the
cowling lock lever(s) and lift off the cowling.
When installing the cowling, check to be sure
it fits properly in the rubber seal. Then lock the
cowling again by returning the cowling lock le-
ver(s) to the lock position.
EMU26430
Carrying handle
A carrying handle is included on the clamp
bracket. After setting the handle up, it enables
you to carry the outboard motor easily with
one hand.
To set up the carrying handle, proceed as fol-
lows:
1.
Place the tilt lock lever in the lock posi-
tion.
2.
Securely hook the arm on the carrying
handle end to the clamp bracket bar.
NOTICE
ECM00080
Place the tilt lock lever in the lock position
while using the carrying handle. Other-
wise, the lower unit could fall to the
ground while carrying the motor.
EMU26410
2-pin connector
AC 12 V-40/60/80W power is delivered
through this connector. When using it, keep in
mind the following points:
●
Use a genuine Yamaha connector.
●
Use lighting equipment only.
●
Connect lighting equipment directly to the
2-pin connector.
●
Capacity of the lighting equipment must be
more than 12 V-40/60/80W; otherwise the
bulb could burn out.
●
When the connector is not in use, place the
cap on it.
NOTICE
ECM01000
Do not connect the 2-pin connector direct-
ly to the battery terminals. Otherwise the
electric system will be damaged.
1. Cowling lock lever(s)
1. Carrying handle
2. Clamp bracket bar
U63V2DE0.book Page 17 Monday, February 22, 2010 9:00 AM
