Yamaha 2006 YSF-R1(V), Дополнительное руководство по обслуживанию

Страница: 31 / 87

SPEC
23
Pass the water hose lower side
of the thermostat, and between
the ground lead and the neutral
switch.
Install the leads so that the
engine ground lead is posi-
tioned lower and the battery
negative lead to be upper.
Install the protrusion of each
lead to be above the vehicle.
Route the crankshaft position
sensor lead under the wire har-
ness.
To the fuel pump
Clamp the wire harness winding
in and insert it to the frame hole. Pass the lead through inside of
the battery band.
Press on the tip of the clamp
after passing the leads through
it.
Insert the tail / brake light lead to
the rear frame hole.
Insert the clamp from the vehi-
cle front to the rear side and fas-
ten each lead, coupler and
onionhead to the fender rib, and
then point the tip of the clamp
(excessive part) to the upper
side of the vehicle.
Hold down the clamp tips after
passing each lead. Make sure to position the cou-
pler at the downmost position of
leads. However, the coupler
should be set in the rear frame
so that it is not caught by the
seat bottom, cover and other
components.
Point the tip of the clamp
(excessive part) to the inside of
the vehicle. Fasten the wire har-
ness with a clamp.
CABLE ROUTING