SPEC
24
Point the tip of the clamp
(excessive part) to the rear side
of the vehicle. Fasten the starter
relay lead, turn signal relay
lead, main fuse lead, main fuse
lead (from the battery positive
lead) and starting circuit cut-off
relay lead with a clamp.
Route each lead upper side the
wire harness.
Fasten the wire harness, battery
negative lead and starter motor
lead with a clamp. Point the tip
of the clamp (excessive part) to
the inside of the vehicle.
Point the tip of the clamp
(excessive part) to the down
side of the vehicle. Fasten the
wire harness, battery negative
lead, A.C. magneto lead and
starter motor lead with a clamp.
To the speed sensor
Insert the wire harness wrap-
ping clamp to the hole of the
frame.
After passing the lead between
the wire harness and starter
motor leads, fastening by the
clamp should be cancelled
and route the lead under the
idle remote controller.
Fasten the wire harness,
A.C.magneto lead, and throt-
tle body lead with a clamp.
Point the tip of the clamp (cut
the tip of the clamp leaving 2
to 4 mm (0.08 to 0.16 in).) to
the inside of the vehicle.
To the air filter
To the throttle body
To install the cover 7, install
so as to set each coupler in
the cover. Make sure that
each lead is not caught by the
cover 7.
CABLE ROUTING
Содержание 2006 YSF-R1(V)
