–5–
CABLE ROUTING
SPEC
1
Throttle stop screw
2
Coolant reservoir tank hose
3
Pickup coil lead
4
Rear brake light switch lead
5
Coolant hose
6
Clutch cable
7
Coolant hose protector
8
Hose clamp assembly
9
Hose clamp
A Pass the rear brake light switch lead outside of rear
engine mount bolt.
B Pass the ignition coil lead outside of the radiator
hose.
C Pass the coolant reservoir tank hose under the
frame and right side of the throttle body.
D Pass the clutch cable inside of the coolant reservoir
tank hose and radiator return hoses.
E Assemble as “
” shown below when clamping.
F Pass the pickup coil lead over the throttle stop
cable.
G Tip of the plastic locking tie shall be pointed to the
inner side at the rear part of the vehicle.
H The punch mark starting point should be lower than
the clamp’s top end.
However, the aiming position of the punch mark
starting point should be 5 mm (0.20 in) below the
clamp’s bottom end.
I Pass the clutch cable inside of the radiator hose.
J Clamp the clutch cable so that it is positioned in this
range.
K Put and apply the hose clamp to it.
a
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
email: [email protected]
