16
Keyfob Battery Change
When the battery is low the LED will glow dimly
when any key is pressed. The battery is changed as
follows:
1
Using a coin turn the battery cover anticlockwise
to the unlocked position and remove cover and
battery.
2
Insert new CR2032 coin cell with the + side
uppermost.
3
Replace battery cover.
Press any key and check that the LED lights. If the
LED lights the new battery installation is successful.
Keypad Battery Change
When the battery is low the LED will flash when any
key is pressed. The battery is changed as follows:
1
Ensure the system is disarmed.
2
Unscrew the two keypad case screws and remove
keypad back to reveal battery.
3
Using a screwdriver gently lever out the old
battery.
4
Insert new CR2032 coin cell with the + side
uppermost.
5
Press battery into holder firmly with finger and
thumb until a click is heard.
6
Press a number key and check that the LED lights.
If the LED lights the new battery installation is
successful, screw keypad back on and the battery
change is complete.
Help Button Battery Change
When the battery is low the LED will glow dimly
when the button is pressed. The battery is changed
as follows:
1
Loosen the bottom case screw and take button
cover off base.
2
Insert new CR2032 coin cell with the + side
uppermost.
3
Replace button cover.
Press the button and check that the LED lights.
If the LED lights the new battery installation is
successful.
Smoke Detector Battery Change
When the battery is low the LED will flash
accompanied with a Low-volume beep once every
30 seconds.
1
Rotate smoke detector anti-clockwise to detach
from base bayonet fixing.
2
Insert new AA alkaline batteries, taking care to
observe polarity and wait 15-20 minutes for he
smoke detector to recalibrate itself, indicted by a
rapidly flashing LED..
3
Replace smoke detector on base and rotate
clockwise to lock.
4
Press the test button and check that the LED
lights and the sounder chimes.
