13
Adding and using Accessories
Adding accessories to your
system
See page 7
Using your keyfob
• The keyfob can be used to Away Arm, Home
Arm, and Disarm the system using the buttons as
shown.
• An emergency alarm can be activated by pressing
the emergency button for 3 seconds until LED
stops flashing.
• An emergency alarm can only be stopped by using
the control unit keypad or a remote keypad.
/
Away
Keypad
Keypad initialisation
If you purchase a keypad as an accessory, you will
need to initialise it prior to use with the control panel.
1
Press ‘Panic button A’ followed by factory default
keypad code ‘0000’ (this is different to your control
panel pincode).
2
The LED will now flash slowly indicating it is in test
(programming) mode.
3
Press ‘Panic button A’ followed by the ‘7’ key to
set the keypad into control panel system mode
(also known as slave mode).
4
Quit test mode by pressing the disarm key twice.
The keypad code and mode setting has been
completed. The keypad will now use the same
pincode that is set for the control panel unit.
Forgotten keypad code (different to disarming
pincode)
If the keypad code is accidentally forgotten, the
keypad can be reset to factory default (0000) using
the following steps:
1
Unscrew the two keypad case screws and remove
keypad back cover (please disable tamper first).
Locate and remove the battery.
2
Press the number ‘4’ key at the same time as
reinserting the battery.
3
Screw the keypad case together and re-learn the
keypad into the system using the steps described
above in this section.
To provide additional protection you can add extra door/window contacts, PIRs, keyfob
remote controls, keypad remote controls, help buttons and smoke detectors. These are
available separately from your local stockist.
ale
Y
1 2
3
6
5
4
7 8 9
0
Panic button A
Panic button B
Disarm
HomeArm
LED
Learn button=
Press 8 and 9 together
/
Away
