19
Install Tongue & Flat-4 Connector
INSTALL TONGUE
Carefully turn the trailer right-side up onto its wheels.
Open the black lever
on the tongue receiver (picture
20A
).
Assembly Tip: Hook up the tongue ball coupler on to your
vehicle hitch ball to hold that end up.
Lightly grease the end of the tongue and put a small amount of
grease on the Tongue Pin. Insert the tongue flush with the rear of
the receiver (push the Flat-4 wire in first – picture
20A
).
Insert the Tongue Pin
with the black lever still open
(picture
20B
). Install the “bow-tie” cotter pin (attached to the lanyard) in
its locked position per the yellow warning label,
to avoid serious
injury or death.
Close the black lever and lock all levers to
prevent theft (picture
20C
).
CONNECT WIRING
Plug in the Flat-4 electrical connector as shown (picture
20D
).
Black
Lock Lever
Open
Tongue
Pin partially
inserted
Flat-4 Connectors
Flat-4 Connection
Completed
Black
Lock Lever closed
after full insertion of
Tongue Pin
Bow-Tie
Cotter Pin Installed
20D
Connect Wiring
20C
Clip on Bow-Tie
20B
Insert Tongue Pin
20A
Insert Tongue
