28-13-011-Rev4
3/17
MEASURE ROOF TRIM
Using a Tape Measure, measure 1420 mm from the edge of the windscreen rubber
(not glass edge) back along rubber roof channel trim. Ensure to measure from the
centre of roof trim as shown. Use a pencil to mark measurement at 1420 mm and
another at 230 mm.
Vehicle Front
NOTE
- image as viewed from above
Rubber roof
channel trim
Windscreen rubber
230 mm
1190 mm
DRILL ROOF TRIM
The measurements can now be carefully drilled through using a 3 mm Drill Bit (not
supplied) by drilling three holes through the trim at the two marked locations. The
trim has a stainless steel section inside.
Do not drill into the roof.
5
Mark measurement
on trim with a pencil
Mark measurement
on trim with a pencil
230 mm
1190 mm
Vehicle Front
!
Warning!
Use care when breaking through the
roof trim to not drill into the roof.
CUT ROOF TRIM
To protect paint work, place Masking Tape over middle of roof as
shown. Gently lever up the middle of rubber roof channel trim with a
Flat Blade Screwdriver (wrap tape around end of Screwdriver to prevent
paint scratching). Use Tin Snips to cut through middle of trim.
6
Masking tape
needs to also
cover the inside
ridge of channel
as shown.
4
!
