Instruction #1036039A - page 6 of 10
OPTIONAL: EXTEND THE ARMS
A. Using a 5 mm hex wrench and 8 mm box
wrench, remove the 2 bolts, washers, and
nuts on each arm.
B. Slide the arms out.
C. Reinstall the bolts, washers, and nuts, and
fully tighten to 8 Nm.
Some vehicles may have interference issues
with certain EXO Accessories installed on EXO
TopShelf™, in which case you will need to change
the EXO TopShelf arms to the outer position.
B
B
A
C
8 Nm
When using EXO TopShelf
™
with EXO DoubleUp
™
,
ensure there is at least 13”
between the handlebars of
the inner bike and the rear
of your vehicle.
Be sure to read all
the warnings and
warranty information
contained in the
insert accompanying
these instructions!
WARNING
IMPORTANT!
• Attachment hardware can loosen over time.
Check and tighten if necessary, before each use.
• Be sure all hardware is secured according to
instructions. Failure to perform safety checks
before driving away can result in property
damage, personal injury, or death.
A. Open the driver-side arm of the EXO SwingBase™.
B. Remove bolts and washers. Lift from EXO SwingBase.
C. Reinstall the cap onto EXO SwingBase.
D. Store EXO TopShelf in a safe place.
WARNING
REMOVAL
NOTE:
Remove accessories from EXO TopShelf™
before uninstalling.
13” (33 cm)
RECOMMENDED ACCESSORIES
Visit Yakima.
com or your
preferred dealer
to purchase or
research these
accessories.
EXO DoubleUp™
EXO SnowBank™
EXO BackDeck™
EXO GearWarrior™
EXO WarriorWheels™
EXO GearLocker™
