Page 5 of 6
Slide 2 x M6 Hex Bolts into the top channel and 2 x M6 Hex Bolts into the bottom
channel of the mounting extrusion on the rear of the awning.
Once all four bolts have been placed into the extrusion, use the measurement from
the previous step to position the bolts so that they align with the holes on the Awning
Brackets.
7
Measure the distance of the centre of the holes in the Awning Brackets between each
crossbar.
Referring to Figure 2, secure each M6 Hex Bolt to the Awning Brackets using 1 x M6
Washer and 1 x M6 Nylock Nut. Tighten all bolts to 4Nm with a 10mm Spanner or a
suitable Torque Wrench.
Fig. 2
M6 Washer
M6 Nylock Nut
M6 Hex Bolt
9
Your awning is now fitted and ready for use. Please refer to your awning's set up
instructions for use.
10
8
SHADE AWNING MOUNTING INSTRUCTIONS
