Page 2 of 6
Fig. 1
Noting the orientation of the Awning Brackets as pictured, check that Awning will
not interfere with opening doors once fitted. If there is not enough clearance use the
alternative orientation of the Awning Brackets. If there is enough clearance, secure the
2 x Awning Brackets to the M8 Spring Nuts in the Crossbars by referring to Figure 1.
Tighten to 4Nm with a 6mm Allen Key or a suitable Torque Wrench.
1
Insert 2 x M8 Spring Nuts at an equal distance from the ends of a pair of crossbars on
the same side of the vehicle. Push Spring Nuts down into the crossbar channels and
twist to lock into place as pictured.
Use the Awning Brackets to ensure Spring Nuts align with holes on the Awning
Brackets.
Awning Bracket
2
a
INSTALLING AWNING BRACKETS DIRECT TO LOCKN’LOAD AND OTHER HEAVY DUTY
CROSSBARS
M8 Spring Nut
M8 Washer
M8 Spring Washer
M8 Socket Head
Capscrew 25mm
Alternative Awning Bracket Orientation
Note - Additional
washers not supplied
2b
Secure the bracket from a Recovery Tracks/Accessory Mount Brackets kit to the top of
each Awning Bracket with the M8 Spring Nuts in the platform slat channels by referring to
Figure 2.
Tighten to 4Nm with a 6mm Allen Key or a suitable torque wrench.
M8 Washer
Awning Bracket
M8 Spring Washer
M8 Socket Head
Capscrew 25mm
M8 Spring Nut
Fig. 5
Mounting Bracket
IF INSTALLING THE RECOVERY TRACKS HOLDER (SOLD SEPARATELY) OR
ACCESSORY MOUNT BRACKETS (SOLD SEPARATELY) IN TANDEM WITH YOUR
AWNING BRACKETS
Recovery Tracks and other accessories
can be fitted to these Brackets as shown.
Refer to the instructions supplied with
these kits for more information.
2c
For Awning mounting instructions,
proceed to Step 7 / Page 5
