Page 4 of 6
5
Push rubber infill down and slide 2 x M8 T-Nuts into each channel at an equal
distance from the ends of a pair of crossbars on the same side of the vehicle. The
6mm Alley key can be used to assist T-Nut installation into the channel.
Use the Awning Brackets to ensure T-Nuts align with holes on the Awning Brackets.
INSTALLING AWNING BRACKETS DIRECT TO WHISPBAR, PRORACK S-WING, AND
INTERNATIONAL T-SLOT CROSSBARS
6a
Noting the orientation of the Awning Brackets as pictured, check that Awning will not
interfere with opening doors once fitted. If there is not enough clearance use the
alternative orientation of the Awning Brackets. If there is enough clearance, secure
the 2 x Awning Brackets to the M8 T-Nuts in the Crossbars by referring to Figure 3.
Tighten to 4Nm with 6mm Allen Key provided or a suitable Torque Wrench.
Fig. 3
M8 Washer
Awning Bracket
M8 Spring Washer
M8 Socket Head
Capscrew 20mm
M8 T-Nut
M8 Washer
Alternative Awning Bracket Orientation
Note - Additional
washers not supplied
6b
Secure the bracket from a Recovery Tracks/Accessory Mount Brackets kit to the top
of each Awning Bracket with the M8 Spring Nuts in the platform slat channels by
referring to Figure 2.
Tighten to 4Nm with a 6mm Allen Key or a suitable torque wrench.
M8 Washer
Awning Bracket
M8 Spring Washer
M8 Socket Head
Capscrew 20mm
M8 T-Nut
Fig. 7
Mounting Bracket
IF INSTALLING THE RECOVERY TRACKS HOLDER (SOLD SEPARATELY) OR
ACCESSORY MOUNT BRACKETS (SOLD SEPARATELY) IN TANDEM WITH YOUR
AWNING BRACKETS
6c
Recovery Tracks and other accessories
can be fitted to these Brackets as shown.
Refer to the instructions supplied with
these kits for more information.
6c
For Awning mounting instructions,
proceed to Step 7 / Page 5
