Yaesu VX-127, Руководство по эксплуатации

Страница: 57 / 88

VX-127 O
PERATING
M
ANUAL
55
DTMF O
PERATION
The
VX-127
is provided the Nine DTMF Autodial memories which allowing you to store
telephone numbers for autopatch use. You can also store short autopatch or Internet-link
access code streams so as to avoid having to send them manually.
Here is the DTMF Autodial storage procedure:
1.
Press the [ SET
( )
EMG
] key momentarily to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 17:
DT WRT
.
3. Press the [
F
] key momentarily to enable adjustment of this Set
Mode Item.
4. Rotate the
DIAL
knob to select the DTMF Memory register (“
d1
”
~ “
d9
”) into which you wish to store this DTMF string.
5. Press the [
F
] key momentarily to begin DTMF Memory entry
into the selected register.
6. Rotate the DIAL knob to select the first digit of the DTMF string.
Selectable entries are 0 - 9, and A - F, with E and F representing
DTMF “
” and “#” tones respectively.
7. Press the [ F
] key to accept the first digit and move to the next digit of the DTMF string.
8. Repeat steps 6 and 7 until you have completed the telephone
number.
9. If you make a mistake, press the [
(
MHz
)] key to move back to
the previous digit, then re-select the correct number.
10. Press and hold in the [ F
] key for one second to save the setting.
11. If you store other numbers, repeat steps 4- 10 above, using a
different DTMF memory register.
12. When all required DTMF memories are filled to your satisfaction, press the
PTT
switch to save the settings and exit to normal operation
To send the Telephone Number, Hold the PTT switch to continue transmitting during
following steps:
1.
Press the [
(
MHz
)] or [ (
MHz
)] key to select the DTMF Memory register (“
d1
” ~
“
d9
”) you wish send.
2. Press the [
LOW
(
LOCK
)
SET
] key momentarily to transmit the tone string. Once the
string begins, you may release the
PTT
switch, as the transmitter will be held “on the
air” until the DTMF string is completed.
You can change the DTMF Autodialer sending speed, using Set Mode Item 16:
DT SPD
.
See page 73 for details.
You can also set a longer delay between the time you press the numerical key (correspond-
ing to the DTMF memory string; with
PTT
switch pressed) and the instant when the first
DTMF digit is sent, using Set Mode Item 15:
DT DLY
. See page 75 for details.