Yaesu VX-127, Руководство по эксплуатации

Страница: 16 / 88

VX-127 O
PERATING
M
ANUAL
14
2) Scanning
Press and hold in either the [
(
MHz
)] or [ (
MHz
)] key
for one second to initiate upward or downward scanning,
respectively (Manual VFO Scan).
For scanning within a limited sub-band range, from the VFO
mode, press and hold in the [
MR
(
SKIP
)] key for one sec-
ond to begin scanning toward a higher frequency within the
previously-defined sub-band (Programmed VFO Scan). De-
tails regarding sub-band setup may be found on page 37.
If you wish to reverse the direction of the scan (i.e. toward a
lower frequency, instead of a higher frequency), just rotate
the
DIAL one click in the counter-clockwise direction while
the VX-127 is scanning
. The scanning direction will be re-
versed. To revert to scanning toward a higher frequency once
more, rotate the
DIAL
one click clockwise.
The scanner will stop when it receives a signal strong enough
to break through the Squelch threshold. The
VX-127 will then hold on that frequency
according to the setting of the “RESUME” mode (Set Mode Item 32:
RESUME
). Press the
PTT switch momentarily to cancel the scanning. This only stops the scan; it does not cause
transmission to occur. See page 36 for details regarding Scan Operation.
O
PERATION
F
REQUENCY
N
AVIGATION
(
P
ROGRAMMED
VFO S
CAN
)
(
M
ANUAL
VFO S
CAN
)