Yaesu VX-127, Руководство по эксплуатации

Страница: 12 / 88

VX-127 O
PERATING
M
ANUAL
10
B
ELT
C
LIP
I
NSTALLATION
Connect the hanger to the rear of the VX-127 , with the notch pointing directly up,
using the supplied screw (Figure 1). Use only the screw included with the clip to
mount the clip to the back of the
VX-127 .
Clip the Quick-Draw Belt Clip onto your belt (Figure 2).
To install the
VX-127
into the Quick-Draw Belt Clip, align the hanger with the Quick-
Draw Belt Clip, and slide the
VX-127
into its slot until a click is heard (Figure 3).
To remove the
VX-127
from the Quick-Draw Belt Clip, rotate the
VX-127
180 de-
grees, then slide the VX-127 out from the Quick-Draw Belt Clip (Figure 4).
I
NSTALLATION OF
A
CCESSORIES
I
NSTALLATION OF
FBA-25A A
LKALINE
B
ATTERY
C
ASE
(
O
PTION
)
The optional
FBA-25A
Battery Case allows operation of the
VX-127
using six “AA” size
Alkaline batteries.
When installing batteries, insert the (–) end first, then press in the (+) end so the battery
snaps into place. Always replace all six batteries at the same time, paying attention to the
polarity indicated inside the case.
The FBA-25A must not be used with rechargeable cells. The FBA-25A does not contain
the thermal and over-current protection circuits (provided in the “FNB” series of Ni-MH
Battery Packs) required when utilizing Ni-Cd and Ni-MH cells.
Note that the power output and battery life will be much shorter when using Alkaline AA
cells. They should be considered an emergency backup power source only, for this reason.
Figure 4
Figure 3
Figure 2
Figure 1