Yaesu VX-127, Руководство по эксплуатации

Страница: 55 / 88

VX-127 O
PERATING
M
ANUAL
53
To activate the ARTS™ feature:
1.
Set your radio and the other radio(s) to the same DCS code number, per the discussion
on page 24.
2. Press the [
SET
( )
EMG
] key momentarily to enter the Set mode.
3. Rotate the
DIAL
knob to select Set Mode Item 2:
ARTS
.
4. Press the [
F
] key momentarily to enable adjustment of this Set
Mode Item.
5. Rotate the DIAL knob to select the desired ARTS™ Beep mode
(see above).
6. Press the [ F
] key mamentarily. You will observe the “
OUT. RNG ”
display on the LCD below the operating frequency. ARTS™
operation has now commenced.
7. Every 25 seconds, your radio will transmit a “polling” call to the
other station. When that station responds with its own ARTS™
polling signal, the display will change to “
IN.RNG
” to confirm
that the other station’s polling code was received in response to
yours.
8. Press the [
F
] key momentarily to exit ARTS™ operation and resume normal function-
ing of the transceiver.
ARTS™ constitutes a form of “remote control” operation that may be re-
stricted to certain frequencies. U.S. users should confirm the current status
of §97.201(b) of the FCC’s rules governing the 430 MHz band of the Ama-
teur service before utilizing this feature.
ARTS™ Polling Time Options
The ARTS™ feature may be programmed to poll every 25 seconds (default value) or 15
seconds. The default value provides maximum battery conservation, because the polling
signal is sent out less frequently. To change the polling interval:
1. Press the [ SET
( )
EMG
] key momentarily to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 3:
AR INT
.
3. Press the [
F
] key momentarily to enable adjustment of this Set
Mode Item.
4. Rotate the
DIAL
knob to select the desired polling interval (
15
or
25
seconds).
5. When you have made your selection, press the
PTT
switch to
save the new setting and exit to normal operation.
ARTS™
(
A
UTOMATIC
R
ANGE
T
RANSPONDER
S
YSTEM
)