Yaesu GS-232B, Руководство пользователя

Страница: 18 / 24

16
c
ommanD
l
ist
In the following command descriptions, the elevation ver-
sion of each command, where there is one, is shown in pa-
rentheses (but don’t type the parentheses). Remember that
elevation commands require the G-5400B , G-5600B or
G-5500 A
z
/E
l
Rotators, or the GX-500 adapter and the
G-500 or G-550 Elevation Rotator.
0
(
O2
)
Offset calibration for the Azimuth (Elevation) : preset ro-
tator manually fully counter-clockwise (“left” horizon for
elevation), send command, and press [
Y
]

[

] (“Y” and
“
E
ntEr
”) on the computer keyboard to store setting.
H
(
H2
,
H3
)
Returns list of commands (see page 19 and 20).
F
(
F2
)
Full Scale Calibration : preset rotator manually to full
scale, send command, adjust
OUT VOL ADJ
trimmer
on rear of controller (or GX-500 elevation adapter) until
the returned data is “+
180
or +
450
” (“+
0nn
+
180
” for
elevation). Press [

] (“
E
ntEr
”) on the computer keyboard
to exit the calibration routine.
R
(
U
)
Start turning the rotator to the right (up)
o
pera
tion
L
(
D
)
Start turning the rotator to the left (down).
A
(
E
)
Stop azimuth (elevation) rotation.
S
Stop: cancel current command before completion.
C
(
B
)
Return current azimuth (elevation) angle in the form
“
AZ=aaa
” (“
EL=eee
” for “B” command) degrees.
C2
Return azimuth and elevation (“
AZ=aaa EL=eee
”, where
“
aaa
” = azimuth, “
eee
” = elevation).
P36
Switch the azimuth angle to 360 degree mode.
P45
Switch the azimuth angle to 450 degree mode.
Z
Toggle the starting point of the azimuth indicator needle
between “N (North)” and “S (South).”
This command is ignored when the rotator is set to “450
degree mode.”