29
Setup (Menu) Mode
The FTM-7250DR/DE Setup (Menu) mode, already described in parts of many previous
chapters, is easy to activate and setup. The Menus may be used to configure many
of transceiver parameters, some of which have not been detailed previously. Use the
following procedure to activate the Setup (Menu) mode:
1. Press and hold the [
MHz
(
SETUP
)] key to enter the
Setup menu.
2. Rotate the
DIAL
knob to select the Menu Item to
be adjusted.
3. Press the [
MHz
(
SETUP
)] key momentarily to en-
able adjustment of the selected Menu item, and
then rotate the
DIAL
knob to perform the actual
adjustment.
4. After completing the selection and adjustment,
press and hold the [
MHz
(
SETUP
)] key to exit the
Setup menu and resume normal operation.
Menu Item
Function
Available Values
Default
1
APO
Enables/Disables the Automatic Power
Off feature.
0.5H to 12H (0.5H step)/
OFF
OFF
2
BCLO
Enables/Disables the Busy Channel
Lock-Out feature.
ON/OFF
OFF
3
BEP KEY
Enables/Disables the key beeper.
KEY+SCAN/KEY/OFF
KEY+SCAN
4
BEP EDGE
Enables/Disable the Band-edge beeper
while scanning.
ON/OFF
OFF
5
BEP LVL
Sets the beep level
HIGH/LOW
HIGH
6
BEP STBY
Enables/Disable the Standby beep
ON/OFF
ON
7
BELL
Selects the CTCSS/DCS/EPCS Bell
Ringer repetitions.
1 to 20/CONTINUE/OFF
OFF
8
CLK TYPE
Shifting of the CPU clock frequency.
A/B
A
9
DC VOLT
Indicates the DC Supply Voltage.
---
---
10 DCS CODE
Setting of the DCS code.
104 standard DCS codes
023
11 DCS INV
Select a combination of DCS inversion
codes in terms of communication direc-
tion.
NORMAL/INVERT/
BOTH
NORMAL
12 DIG AMS
Sets the transmission mode
TXMANUAL/TX FMFIX/
TX DIGTL/AUTO
AUTO
13 DIG VW
Turn the VW mode selection ON or OFF. ON/OFF
OFF
14 DI POPUP
Sets the information pop-up time
2/4/6/8/10/20/30/60/
CONTINUE/OFF
10 SEC
15 DPID LST
DP-ID list (Display/Register/Clear)
(Registered DP-ID)
---
16 DT AUTO
Enables/Disables the DTMF Autodialer
feature.
MANUAL/AUTO
MANUAL
17 DT DELAY
Setting of the DTMF Autodialer TX Delay
Time.
50/250/450/750/1000
450 MS
