28
Clone
The FTM-7250DR/DE includes a convenient “Clone” feature, which allows the memory
and configuration data from one transceiver to be transferred to another FTM-7250DR/
DE.
This can be particularly useful when configuring a number of transceivers for a public
service operation.
Here is the procedure for cloning data from one radio to another:
1. Turn both radios OFF.
2. Connect the user-constructed cloning cable between the MIC jacks of the two radios.
3. Press and hold the [
MHz
(
SETUP
)] key while turn-
ing the radios ON. Do this for both radios (the or-
der of switch-on does not matter). “CLONE” will
appear on the displays of both radios when the
Clone mode is successfully activated in this step.
4. On the Destination radio; press the [
MHz
(
SETUP
)]
key (“-- --WAIT-- --” will appear on the display).
5. On the Source radio; press the [
GM
(
AMS
)] key “--
-- --TX-- -- --” will appear on the Source radio, and
the data from this radio will be transferred to the
destination radio.
6. If there is a problem during the cloning process,
“ERROR” will be displayed. Check your cable con-
nections and battery voltage, and try again.
7. If the data transfer is successful, “CLONE” will ap-
pear on the Source radio display. The destination
radio, to which the data is copied, will restart auto-
matically.
8. Turn both radios off and disconnect the cloning cable.
Pin 1: PTT/CLONE
Pin 1: PTT/CLONE
Pin 3: GND
RJ12/6
6 Position 6 Contact
Modular Plug
RJ12/6
6 Position 6 Contact
Modular Plug
Pin 3: GND
