74
S
ca
n
n
in
g
The FTM-400DR/DE transceiver will scan the frequencies registered in the memories in
the order of the memory channel number.
1
Switch to the memory mode
2
Press
briefly
The function menu will be displayed.
3
Touch
Tip
When
is not displayed in the function menu,
touch
or
to switch the menu.
The scanning will start from the lowest to the highest
memory channel number.
During scanning, the decimal point of the frequency
display will blink.
When a signal is received, the scan will stop for three
seconds before starting to scan again.
Tips
• The scan can also be started by pressing the
or
button on the microphone for one second or
longer.
• The scanning direction (UP/DOWN) can be set using
in the
set-up menu.
• The action to be taken when scanning is stopped can be set using
in the set-up menu (refer to the previous page).
• The squelch level may be adjusted using the following procedure during scanning.
Touch
To stop the scanning, either touch
or press the microphone
button (the
radio will not transmit in this case).
