17
Scanning
FTM-3200DR Advance Manual
Memory Skip Scanning
When some memory channels are continuously active, you may wish to
skip
them during
scanning
, but still have them available for
manual selection
.
To mask a memory to be skipped (only) during scanning, use the following procedure:
1. Set the radio to the Memory Recall mode by
pressing the [
V/M
(
MW
)] key repeatedly, as
necessary, until
“
”
and a channel number
appear on the right side of the display.
2. Rotate the
DIAL
knob to select the Memory
Channel to be skipped during scanning.
3. Press and hold in the [
MHz
(
SETUP
)] key for
one second, then rotate the
DIAL
knob to
select “
SCAN SKP 40
”.
4. Press the [
MHz
(
SETUP
)] key, then rotate
the
DIAL
knob to select “SKIP”. The current
Memory Channel will now be ignored during
scanning.
VOL
DIAL
SQL
TXPO
D W
M W
SETUP
REV
D/A
V / M
M H z
VOL
DIAL
SQL
TXPO
D W
M W
SETUP
REV
D/A
V / M
M H z
5. Press and hold in the [
MHz
(
SETUP
)] key for
one second to save the new setting and exit
to normal operation.
Blinks
A blinking “ ” icon will appear when you recall
the “skipped” memory channel manually.
To reinstate a channel into the scanning loop,
select “OFF” in step 4 above, after first recalling
the currently blocked channel (the “Skipped”
channel is accessible via manual channel
selection methods using the
DIAL
knob in the
Memory mode, whether or not it is locked out of
the scanning loop).
Blinks
