9
Connecting to a Faraway Station Using WIRES-X
Connecting to the other node ID or the other room ID
1
Rotate the DIAL to set the operating band to the
frequency of the desired local node.
2
Set the WIRES-X DG-ID to the same ID number
as the node station. Refer to “The DG-ID feature to
access the WIRES-X node station” (page 33).
3
Press and hold
for over one second.
[
X ]
flashes on the left side of the frequency display.
When a local node is found,
[
X ]
is lit solid, and the
node name and city name appear on the upper part
of the screen.
Tip
Depending on the connection status, the screen will
show one of four display patterns.
(1)
Connected to the local node, but unable to connect
to Internet nodes or rooms (never before established
connection to Internet nodes or rooms)
(2)
Connected to the local node, but unable to connect
to Internet nodes or rooms (previously succeeded in
establishing connection to Internet nodes or rooms)
(3)
Connected to the local node, successfully connected
to an Internet node or room (the Internet node or
room is the same as the one used before)
(4)
Connected to the local node, successfully connected
to an Internet node or room (the Internet node or
room is different from the one used before)
When is displayed, rotate the DIAL. Call signs
of nodes and rooms on the Internet you previously
connected to flash.
Tip
While
[
X ]
is flashing, briefly press the
key to re-establish connection to the local
node.
Tip
When any local node cannot be found,
[
X ]
will disappear in five minutes.
Tip
When the detected local node is a repeater station,
[
[ R ] ]
appears below
[
X ].
Caution
WIRES-X can only be used on the operating band.
