Yaesu FT DX 9000D - COMPUTER AIDED TRANSCEIVER, Руководство по эксплуатации

Страница: 109 / 156

Page 107 FT
DX
9000D O
PERATION
M
ANUAL
CW C
ONVENIENCE
F
EATURES
Message Memory Programming (Using Your Paddle)
1. Press the CW mode switch (# ) to engage CW
operation.
2. Set the BK-IN/SPOT switch (# ) to Off.
3. Turn the internal Electronic Keyer On by pressing the
KEYER switch (# ), if necessary.
C
ONTEST
M
EMORY
K
EYER
4. Press the FH-2’s MEM key.
5. Press the 1 ~ 5 key on the FH-2 to begin the
memory storage process.
6. Send the desired message using your keyer paddle.
7. Press the MEM key on the FH-2 once more at the
end of your message. Up to 50 characters may be
stored among the five memories.
Note
You must exercise care in sending to ensure that the spaces be-
tween letters and words are accurately done; if your timing is off,
the spacing may not come out right in the stored message.
For ease in setting up the keyer memories, we recommend you set
Menu item “MODE-CW 041 F-KEYER TYPE” (KEYER FRONT)
and/or “MODE-CW 043 R-KEYER TYPE” (KEYER REAR)” to
“ACS” (Automatic Character Spacing) while you are program-
ming the keyer memories.
Checking the CW Memory Contents
1. Be sure that Break-in is still turned Off.
2. Press the FH-2’s 1 ~ 5 key to check your work.
You will hear the results in the sidetone, but no RF
energy will be transmitted.
On-The-Air CW Message Playback
1. Press the BK-IN/SPOT key (# ) to enable trans-
mission. Either Full- or Semi-break-in will be engaged,
depending on the setting of Menu item “MODE-CW
047 CW BK-IN.”
2. Press the FH-2’s 1 ~ 5 key to transmit the pro-
grammed message.
Note
If you subsequently decide to use the “Text” technique for memory
storage, please note that the contents of a message stored using
keyer paddle input will not be transferred over when you select
“TEXT” on a particular memory register.
LOCK
OFF ON
LOCK
OFF ON
LOCK
OFF ON
LOCK
OFF ON
Transmitting in the Beacon Mode
It is possible to transmit, repetitively in a “Beacon” mode, any
message programmed either via paddle input or via the “Text”
input method. The time delay between message repeats may be
set anywhere between 0 and 255 seconds via Menu item “FH-2
SET 021 BEACON TIME.” If you do not wish the message to
repeat in a “Beacon” mode, please set this Menu item to “Off.”
Press the 1 ~ 5 key, depending on the register into which
the Beacon message is stored. Repetitive transmission of the Bea-
con message will begin. Press one of these keys once more to
halt the Beacon transmissions.