Yaesu FT DX 9000 CONTEST - 2, Руководство по эксплуатации

Страница: 119 / 168

Page 117 FT
DX
9000 C
ONTEST
O
PERATION
M
ANUAL
M
ENU
M
ODE
017. ROTATOR START UP
Function : Selects the starting point of your controller’s
indicator needle.
Available Values : 0/90/180/270º
Default Setting : 0º
018. ROTATOR OFFSET ADJ
Function : Adjusts the indicator needle precisely to
the starting point set in menu selection 123.
Available Values : –30 - 0
Default Setting : 0
019. RIGHT TX METER
Function : Selects the Sub meter function
Available Values : ALC/VDD
Default Setting : ALC
ALC: Indicates incoming signal strength on the sub
band (VFO-B) while receiving, and indicates the
ALC (Automatic Level Control) operating range
while transmitting.
VDD: Indicates the Vdd (final amplifier drain voltage)
at all times.
020. QMB MARKER
Function : Enables/Disable the QMB Maker (White
arrow “
V
”) to display on the Spectrum Band Scope.
Available Values : ENABLE/DISABLE
Default Setting : ENABLE
Advice : If the optional Data Management Unit ( DMU-
9000 ) is not installed, this selection has no effect un-
less you are using an external display in conjunction
with the
DMU-9000 .
FH-2 SETUP G
ROUP
021. BEACON TIME
Function : Sets the interval time between repeats of
the beacon message.
Available Values : OFF/1 ~ 255 sec
Default Setting : OFF
022. CONTEST NUMBER
Function : Selects the Contest Number “Cut” format
for imbedded contest number.
Available Values : 1290/AUNO/AUNT/A2NO/A2NT/
12NO/12NT
Default Setting : 1290
1290: Does not abbreviate the Contest Number
AUNO: Abbreviates to “A” for “One,” “U” for “Two,”
“N” for “Nine,” and “O” for “Zero.”
AUNT: Abbreviates to “A” for “One,” “U” for “Two,”
“N” for “Nine,” and “T” for “Zero.”
A2NO: Abbreviates to “A” for “One,” “N” for “Nine,”
and “O” for “Zero.”
A2NT: Abbreviates to “A” for “One,” “N” for “Nine,”
and “T” for “Zero.”
12NO: Abbreviates to “N” for “Nine” and “O” for
“Zero.”
12NT: Abbreviates to “N” for “Nine” and “T” for
“Zero.”
023. CW MEMORY 1
Function : Permits entry of the CW message for mes-
sage register 1.
Available Values : TEXT/MESSAGE
Default Setting : MESSAGE
TEXT: You may enter the CW message from a
supplied
FH-2 Remote Control Keypad.
MESSAGE: You may enter the CW message from
the CW keyer.
024. CW MEMORY 2
Function : Permits entry of the CW message for mes-
sage register 2.
Available Values : TEXT/MESSAGE
Default Setting : MESSAGE
TEXT: You may enter the CW message from a
supplied
FH-2 Remote Control Keypad.
MESSAGE: You may enter the CW message from
the CW keyer.
025. CW MEMORY 3
Function : Permits entry of the CW message for mes-
sage register 3.
Available Values : TEXT/MESSAGE
Default Setting : MESSAGE
TEXT: You may enter the CW message from a
supplied
FH-2 Remote Control Keypad.
MESSAGE: You may enter the CW message from
the CW keyer.
DISPLAY G
ROUP