Yaesu FT-847, Руководство по эксплуатации

Страница: 91 / 108

89
FT-847 O
PERATING
M
ANUAL
Menu System
M
ENU
S
ELECTION
D
ETAILS
39 [
ALL INIT
]
Function : Reset microprocessor, restoring all
factory defaults.
While in this Menu selection, pressing the [ MCK/W ]
key causes all Memories and Menu selections to be
returned to their default factory settings.
40 [
5167KHZ
]
(U.S.A. version only)
Function : Enable T
X
/R
X
operation on the
Alaska Emergency Channel,
5167.5 kHz.
Available Values : O
N
/O
FF
Default Setting : O
FF
When this Menu selection is set to O
N
, the spot fre-
quency of 5167.5 kHz will be enabled. To get to this
frequency, use the [
7 (
q
) BAND ] or [ 8 (
p
) BAND ]
keys to navigate; the Alaska Emergency Channel will
be found between the 3.5 MHz and 7 MHz bands as
you press the above-mentioned [
BAND
] keys. See
page 59 for details.
Note : Use of this frequency is restricted to amateurs
operating in (or within 92.6 km of) the U.S. State
of Alaska, and it is to be used for emergency
communications only (involving the immediate
protection of life or property).
41 [
X RPT
]
Function : Activate/Deactivate Cross-Band
Repeat mode.
Available Values : O
N
/O
FF
Default Setting : O
FF
Be certain that the desired transmit and receive fre-
quencies have been set, and that the Squelch is closed
(“B
USY
” should not be visible on the LCD), before ini-
tiating the Cross-Band Repeat mode.
90 [
DCS-DEC
]
Function : Select “Normal” or “Inverted”
DCS coding on Receive (Decoder).
Available Values : N
OR
/I
N
Default Setting : N
OR
Keep this selection set to “N
OR
” unless you are cer-
tain that the other station(s) will be using “Inverted”
DCS coding.
91 [
DCS-ENC
]
Function : Select “Normal” or “Inverted”
DCS coding on Transmit (En-
coder).
Available Values : N
OR
/I
N
Default Setting : N
OR
Keep this selection set to “N
OR
” unless you are cer-
tain that the other station(s) will be using “Inverted”
DCS coding.
•
After selecting Menu #35, press the [ MCK-W ] key
momentarily.
‚
Rotate the MEM/VFO CH knob to select the Satellite
Memory to which an Alpha-Numeric Tag is to be ap-
pended.
ƒ
Rotate the
SUB-TUNE
knob to select the first char-
acter of the Tag.
„
Rotate the
MEM/VFO CH
knob clockwise one click
to select the next letter/number position.
…
Repeat steps
‚
and
ƒ
as needed to fill out the Al-
pha-Numeric Tag contents. In the above example, the
Tag shows “
OSCAR10B
” for “Oscar 10, Mode B.”
†
Press the [ MCK-W ] key momentarily when entry of
the Alpha Tag is completed.
‡
Press the [ MENU ] key to exit the Menu mode.
Satellite Memory Alpha-Numeric Tag Programming