Yaesu FT-7800R, Руководство по эксплуатации

Страница: 50 / 80

48 FT-7800R O
PERATING
M
ANUAL
The Smart Search feature allows you to load frequencies automatically according to where
activity is encountered by your radio. When Smart Search is engaged, the transceiver will
search above and below your current frequency, storing active frequencies as it goes (with-
out stopping on them even momentarily); these frequencies are stored into a special Smart
Search memory band, consisting of 31 memories (15 above the current frequency, 15 below
the current frequency, plus the current frequency itself).
The Smart Search feature is especially useful when visiting a city for the first time, where
you may be unfamiliar with the repeater frequencies; Smart Search discovers where the
local activity is to be found, and automatically loads those frequencies for you.
Two basic operating modes for Smart Search are available:
SINGLE : In this mode, the transceiver will sweep the current band once in each direction
starting on the current frequency. All channels where activity is present will be
loaded into the Smart Search memories; whether or not all 31 memories are filled,
the search will stop after one sweep in each direction.
CONT : In this mode, the transceiver will make one pass in each direction as with One-Shot
searching; if all 31 channels are not filled after the first sweep, however, the radio
will continue sweeping until they are all filled.
Setting the Smart Search Mode
1. Press and hold in the [
BAND
(
SET
)] key for 1/2 second to enter the Set mode.
2. Rotate the DIAL knob to select Menu #36 ( S SRCH ).
3. Press the [
BAND
(
SET
)] key momentarily, then rotate
the DIAL knob to select the desired Smart Search mode
(see above).
4. Press the [ BAND
(
SET
)] key momentarily to save the
new setting, then press and hold in the [
BAND
(
SET
)]
key for 1/2 second to exit to normal operation.
S
MART
S
EARCH