Scanning
The
FT-65R/E
makes available scanning of the stored memory channels, or
scanning of the entire operating band, or scanning of a programmable sub
band portion. Scanning will halt when signals are encountered, and commu-
nication may be initiated on that frequency.
Operation is basically the same in each of the above scanning modes. Be-
fore beginning, take a moment to select the way the scanning will resume
after it halts on a signal.
Setting the Scan-Resume Technique
Three options for the Scan-Resume mode are available:
Display
Description
BUSY
(default setting)
In
BUSY
mode, the scanner will halt on a signal it en-
counters. Scanning will resume one second after the
other station signal ceases transmitting. In the case
of constant-carrier signals like Weather Station broad-
casts, the scanner will likely remain on this frequency
indefinitely.
HOLD
In
HOLD
mode, the scanner will halt on a signal it en-
counters.
Scanning will only resume when it is manually re-initiat-
ed.
TIME
In
TIME
mode, the scanner will halt on a signal it en-
counters, scanning will resume after five seconds even
if a signal is still on the frequency. To cancel scanning,
press the the
PTT
switch, [▲] or [▼] key.
1. Press and hold the
F
key to enter the Set mode.
2.
Press the [▲] or [▼] key to select Set Mode Item “
25 RESUME
”.
3. Press the
F
key to enable adjustment of this Set Mode Items.
4.
Press the [▲] or [▼] key to select the desired
scan-resume mode.
5. Press the
PTT
switch to save the setting and
exit to normal operation.
35
FT-65R/FT-65E Operating Manual
