Yaesu FT-51R, Руководство пользователя

Страница: 55 / 78

With your ID entered, you can repeat this
procedure to the remaining memory
slots (use to select a message slot)
with any messages you like. Note that is
only displayed when the slot reserved for this
purpose is selected.
Sending Messages
Before sending a message, you must first in-
form the other station to switch his or her trans-
ceiver into its message reception mode. With
that done, any stored messages can be sent using
the following procedure:
Press as before, until the desired
mode (message or message ID) is selected
(indicated by or appearing at
the left of the display).
Press and hold the
PTT
while also pressing
the depressed, use the
buttons to choose the slot
the message you want to send, press
release the You will hear the
DTMF string of the message (and
ID
if se-
lected) as it is being sent.
Sending Messages Manually
If you do not have a particular message in
memory (or the time to store it), you can send it
manually by using keypad button combinations.
As explained before, message format consists of
a DTMF
#
followed by up to twelve message
characters, ending with an additional
#.
When
sending a pre-stored message, the are auto-
matically inserted by the FT-51R’s
CPU. When
sending messages manually, however,
remember
to include these.
Unlike DTMF numerals, which are entered
with a single key, letters of the alphabet and
other symbols each require a
two-button key se-
quence.
For example, generating the letter re-
quires manually entering So as you
can see, sending messages manually takes a little
practice and limber fingers. The table on page 60
shows the key sequences required to generate
each of the available characters.
STEPPRS
Press and hold the during the message
string; press followed by your message,
then again before releasing the
PTT.
PRI