Yaesu FT-51R, Руководство пользователя

Страница: 32 / 78

To store a frequency in memory:
Select the desired frequency (and repeater
split manually, if desired) in the VFO mode as
already described.
Hold (until a second beep
sounds). The icon appears blinking.
Within five seconds of pressing turn the
DIAL
or press or
to select the desired
memory for storage. If you select one that is
already being used (stored with data), it will
be overwritten with new data in the next step.
Press momentarily to store the dis-
played data into the selected memory. The
memory label stops blinking for a second,
then disappears as operation continues in the
VFO mode. If you timed out, nothing new was
stored into the memory (simply start again).
Example: Store the repeater data
in memory 5.
First set up the desired frequency and offset
on the VFO (see page
18).
for ( blinks) so the
memory channel number is displayed, then
do the next step within 5 seconds.
Hold
A
Turn the
DIAL
or if necessary,
so that
(the memory number to store)
blinks in the lower display.
Press again, momentarily. That's it. The
VFO data has been stored in memory 5, and
you are left operating on the VFO.
Turn the
DIAL
to change the VFO frequency,
then press to change from the VFO to the
memory mode. You should see appear in
the display bottom, and (the receive fre-
quency) should appear on the top right of the
display. You can press (REV) to confirm the trans-
mit frequency of 442.50 Any memory can
be used with the same result except
which requires a
different procedure.
Notice that pressing from the VFO mode
always recalls the
last stored used
memory.