Yacht Devices YDTA-04N, Руководство пользователя

Страница: 23 / 40

— 23 —
Example 1.
Get the tank number of the channel A:
YD:TANK A
Example 2.
Set the tank number of the channel B to 5:
YD:TANK B 5
2.2 YD:FLUID <A..D> [type]
Where: [type] can be a number 0..15 or one of NMEA 2000 predefined types, they have numbers 0..6
correspondingly (DIESEL, WATER, WASTE, LIVEWELL, OIL, SEWAGE, GASOLINE)
Sets the fluid type for the specified channel or returns the type if the second parameter is omitted. Note that
GASOLINE type (6) and types 7..15 (without defined meaning) are not supported by some chart plotters.
Example: configure the tank of channel B to fresh water, two options:
YD:FLUID B WATER
YD:FLUID B 1
2.3 YD:CAPACITY <A..D> [UNKNOWN | 0..99999]
Sets the capacity of tank at the specified channel in liters. Factory setting is UNKNOWN, with this setting
only a percentage value is transmitted to NMEA 2000. Note that chart plotters display the tank volume
depending on their own regional settings (liters, US gallons, etc.).
2.4 YD:DAMPING <A..D> [0..600]
The factory settings is 3 (seconds) for all channels. Fluid level values, measured by the fluid level sender, can
be unstable in rough sea conditions. You can increase the damping time constant if you find that the fluid
level data reported by the Device is too sensitive to the boat attitude. The value 0 turns off the damping.