Example 1.
Set the 1 hour 3 minutes and 30 second offset:
YD:HOURS 63.5
3.2 YD:VOLTMETER [-1.25 .. 1.25]
Factory setting is 0. Fixed offset for voltage measurements in Volts, can be used to
compensate voltage dropout in wires.
3.3 YD:24V [ ON | OFF ]
Factory setting is OFF. Turn the setting ON if the NMEA 2000 is powered from 12V
battery from a 24V batteries bank to double voltage readings. This setting is applied
after YD:VOLTMETER. After turning on, do not forget to adjust the levels of low
battery warning and charging indicator (VI.5).
3.4 YD:DAMPING_VOLT [0 .. 3.0]
Factory setting is 2.0, the damping time for voltage readings in seconds. The damping
works smart and does not average readings if the value changes sharply. When the
Device is located inside the engine and far from the battery, its power supply circuit
may have interference that interferes with accurate measurements. A bigger damping
value can solve this problem. The Device measures the voltage 6 times per second:
settings of 0.2 or 0.3 are equal to 0 and turns the damping off, and a setting of 0.4 will
count the two last measurements.
3.5 YD: DAMPING_RPM [0 .. 3.0]
Factory setting is 1.0, the damping time for RPM readings in seconds. The damping
works smart and does not average readings if the value changes sharply. The Device
measures engine revolutions 6 times per second: settings 0.2 or 0.3 are equal to 0 and
turn the damping off, the setting 0.4 will count the two last measurements, and the
setting 1.0 will count 6 last measurements.
— 23 —
